Server application

Hardware requirement:

• THRONE 3D Control Server (hereinafter referred to as "server");
• USB flash drive, should have at least 200 MB of available space (hereinafter referred to as "flash drive");

Installation:

• copy server application file throne-server.bin into the root of flash drive;
• insert your flash drive into any server's USB port;
• wait for a double beep (it sounds not in every server models; if sound signal is not supported just wait for 10 seconds) (message "throne-server.bin was installed" will be displayed if monitor is connected to the server);
• remove flash drive from USB port.

Server application is installed on server.

After following the steps above your server application will automatically run on server. An application will also start up automatically after server rebooting.

Updating:

• copy server application file throne-server.bin into the root of flash drive;
• insert your flash drive into any server's USB port;
• wait for a double beep (it sounds not in every server models; if sound signal is not supported just wait for 10 seconds) (message "throne-server.bin was installed" will be displayed if monitor is connected to the server);
• remove flash drive from USB port.

New version of server application is downloaded.

After following the steps above your server application will automatically run on server. You needn't rewrite project file if any project was downloaded to sever.